Goober: Created page with "{{RF1Tutorial|reaper_47}} '''NOTE:''' This tutorial was originally posted on redtechnologies, which is no longer available. ===What are Smoothing Groups?=== Smoothing groups..."

2020-11-18T23:05:16Z

Created page with "{{RF1Tutorial|reaper_47}} '''NOTE:''' This tutorial was originally posted on redtechnologies, which is no longer available. ===What are Smoothing Groups?=== Smoothing groups..."

New page

{{RF1Tutorial|reaper_47}}
'''NOTE:''' This tutorial was originally posted on redtechnologies, which is no longer available.

===What are Smoothing Groups?===
Smoothing groups can be used to make polygon edges of "rounded" geometry appear softer. A typical use would be a pipe like on the picture below.

[[File:SmoothingGroups1.jpg|Smoothing groups]]

Actually, smoothing groups are just lighting effects. Normally every face of a brush is lit separately resulting in an ugly facet effect like on the left picture. What smoothing groups do is just blending the light between all faces that are part of the same group.

===Using Smoothing Groups===
Fortunately, smoothing groups are very easy to add.

For this tutorial simply create a room with a [[RED Brushes#Sphere|sphere shaped brush]] in the middle. Because it is a lighting effect you have to put a [[RED Objects#Light|light]] somewhere near the sphere. Rebuild your level and calculate lighting. You will clearly see the facet effect on the sphere.

Smoothing groups are managed with texture-properties for some reason so go to [[RED User Guide#Texture Mode|texture mode]] first (shift-T). Select one face of the sphere and press shift-S to select all faces of the brush. Press ctrl-P to bring up their [[RED User Guide#Face Properties|face properties]].

See the list in the properties window? These are our smoothing groups. Check the first group. Now all the [[RED Brushes#Sphere|sphere]]'s faces are part of this group. Rebuild your level and calculate lighting again. You should now see a much smoother [[RED Brushes#Sphere|sphere]]!

Please note that the effect doesn't work perfectly every time. Lighting is a complicated thing to render and sometimes you will see ugly edges even though you applied smoothing groups to faces. In some rare cases [[RED]] even crashes when you use groups for too many faces or complicate polygon structures.

[[File:SmoothingGroups2.jpg|Smoothing groups]]

===What are those numbers?===
The huge list in the [[RED User Guide#Face Properties|face properties]] window is actually not neccessary. Mostly you only need the first group for the whole level. Theoretically you can use multiple groups for faces on one and the same brush. That way a hard edge stays between two smoother areas. This doesn't work very well in RED though.

The 89.90 stands for "89.90 degrees" which means that only polygons that meat at a higher angle will be smoothed. I think this value can't be changed in [[RED]]]. I wouldn't care that much about these numbers also. They only seem to be relics from 3D modeling programs where smoothing groups are used much more frequently.

Ok that's it! Happy smoothing :D

[[Category: Red Faction]]
[[Category: RF1 Editing]]
[[Category: Tutorials]]
[[Category: Archived RF1 Content]]

Smoothing Groups - Revision history

Goober: Created page with "{{RF1Tutorial|reaper_47}} '''NOTE:''' This tutorial was originally posted on redtechnologies, which is no longer available. ===What are Smoothing Groups?=== Smoothing groups..."